Möve
Quick Start Guide and User Guide
Attached are two essential resources to help you get started with your Möve: Quick Start Guide: This document walks you through the setup and initial use of the system, perfect for getting started quickly. User Guide: A complete guide covering all ...
Disassembly instructions
Before any use, please follow these instructions carefully to ensure proper disassembly of the system and to avoid accidents. 1. Shutting Down the Computer A) Using the remote control, hold down the Power button for 3 seconds to switch off the ...
Assembly Instructions
Before any use, carefully follow these instructions of the complet user manual to ensure proper assembly of the system and avoid accidents. Note: Be cautious when handling the devices to avoid pinching hazards. It is recommended to carefully read the ...
Optimal projection and playground area for best experience
Projection Recommended dimensions: 6 m (20’) wide × 3.4 m (11’) high Minimum recommended dimensions: 3.7 m (12’) wide × 2 m (6.75’) high Aspect ratio: 16:9 Note: A) The projection surface must be rigid, flat, and as light-colored as possible. B) The ...
Calibrate the camera
If automatic calibration is successful, you will be redirected to the Lü home screen. However, in case of failure, the system will offer the option to proceed with manual calibration. Follow the on-screen instructions to manually calibrate the ...
Optimal Projector Adjustment
Once the auto-adjustment is complete, the following options will appear on screen : If the size, positioning, and focus of the projection are satisfactory, press OK. Otherwise, you can: Press Esc to retry automatic adjustment. Press Play to proceed ...
Recommended position for the base
When the projector is turned on, the system may indicate that the unit is too close or too far from the wall. Before proceeding, it is important to properly reposition the unit to ensure an optimal experience. A) Your unit is too close, you must move ...
Powering Up Your Möve
Make sure that: the power cable is properly plugged in, the power switch is in the ON position, and the head is properly locked into the base. Turn on the projector using the projector controller. If the problem persists, refer to Section 18 – ...
Möve - How to calibrate the camera
Calibration guide for accurate ball detection with a Möve configuration Calibration is necessary when the detection of the ball on the wall is inaccurate or when there are false detections. This usually occurs when the camera is hit by a ball. Even a ...