Powering Up Your Möve

Powering Up Your Möve

Make sure that:

  • the power cable is properly plugged in,

  • the power switch is in the ON position,


  • and the head is properly locked into the base.

  • Turn on the projector using the projector controller.

If the problem persists, refer to Section 18 – Troubleshooting of this manual and contact the technical support team.


Still have questions? Contact us!

      • Related Articles

      • Recommended position for the base

        When the projector is turned on, the system may indicate that the unit is too close or too far from the wall. Before proceeding, it is important to properly reposition the unit to ensure an optimal experience. A) Your unit is too close, you must move ...

      • Möve - How to calibrate the camera

        Calibration guide for accurate ball detection with a Möve configuration Calibration is necessary when the detection of the ball on the wall is inaccurate or when there are false detections. This usually occurs when the camera is hit by a ball. Even a ...

      • Resolving the Spinning Shapes Visual Issue After Sleep Mode - Fixed with 2.0.4.2 release

        Issue When the Lü software resumes after the computer has been in sleep mode, it may become stuck on the spinning shapes visual and fail to load the main interface. Solution Ensure the Lü software is updated to version 2.0.4.2 via the settings menu ...

      • Disassembly instructions

        Before any use, please follow these instructions carefully to ensure proper disassembly of the system and to avoid accidents. 1. Shutting Down the Computer A) Using the remote control, hold down the Power button for 3 seconds to switch off the ...

      • Quick Start Guide and User Guide

        Attached are two essential resources to help you get started with your Möve: Quick Start Guide: This document walks you through the setup and initial use of the system, perfect for getting started quickly. User Guide: A complete guide covering all ...