Troubleshoot for Lü keyboard-remote
1. Make sure the keyboard-remote is fully charged.
2. Ensure that it is set to “ON” and that a blue light is illuminated.
- If a blue light is flashing, the keyboard-remote’s battery is running low and needs to be charged.
- The red light will turn off once the device is fully charged.
3. Make sure to use the keyboard-remote within 30 feet of its receiver, located at the heart of the system.
4. If the keyboard-remote is not charging, try using another USB cable of the same type.
5. If an orange light is flashing without pressing any buttons, it means the keyboard-remote is no longer paired with its USB receiver.
To re-pair it, follow these steps:
- Turn off the keyboard-remote.
- Press and hold the F1 key.
- While holding F1, turn on the keyboard-remote, then release the key immediately.
- Wait a moment; the keyboard-remote will reconnect automatically.
6. If the keyboard-remote is still flashing, repeat the procedure from #5 but with these additionnal steps:
- Disconnect the USB receiver connected at the end of this USB cable.
- Turn off the keyboard-remote.
- Press and hold the F1 key.
- While holding F1, turn on the keyboard-remote, then release the key immediately.
- Reconnect the USB receiver removed at step #2.
- Wait a moment; the keyboard-remote should reconnect automatically.
7. If your keyboard-remote has suffered physical damage, you can purchase a new one from our online store or contact our support team.
If the keyboard-remote no longer holds a charge, there may be an internal issue. It will likely need to be replaced.Additional Tips for Projector Remote Control
Battery Check
Ensure the projector remote’s batteries are in good condition. Replace them if needed.
Optimal Usage Position
The projector's remote sensor is located at the front of the projector. For best results:
Stand near the projection wall.
Aim the remote toward the front of the projector.
Refer to the provided diagram for recommended usage positions.
If issues persist, contact our support team at support@play-lu.com.
Related Articles
Replacing the Keyboard - Remote
Your keyboard remote can be replaced if it no longer works or has been damaged beyond use. To order a new keyboard remote, please visit https://play-lu.odoo.com/. After receiving the new remote, open the back panel to remove the USB receiver. This ...How to set up a remote session with Lü
1. Go to play-lu.screenconnect.com 2. Enter the code provided by Lü 3. Download and install the file that appears after entering the code. 4. Once the installation is complete, please wait for someone from Lü to remotely access your system. Still ...Best Practices
1. Starting Lü: Turn on the projector and the remote keyboard remote. Wake up your Lü by pressing any key on the keyboard remote to start using it. 2. Troubleshooting: If something is wrong with the system, restart the computer first. In the Lü ...Fixing remote pairing: Flashing orange light
An orange flashing light on the keyboard remote, even when no keys are being pressed, indicates that it is no longer paired with its USB receiver. To re-synchronize the keyboard remote, follow these steps: 1. Turn off the remote. 2. Press and hold ...How to adjust the volume of your Lü
If you don't have any volume with your Lü, please check this article 1. Master Volume: Using the keyboard remote, press the V+ key to turn up the Windows volume. Press the V- key to turn down the Windows volume. This controls the master volume of the ...